This is a complete kit to convert from a single reservoir master cylinder system to much safer and more reliable 1967 Corvette style dual reservoir master cylinder system. This kit includes: New non-power master cylinder,...
1963-82 Corvette KYB Gas-A-Just set of four (4) shocks (2 front, 2 rear). These shocks have a high pressure nitrogen gas charge over the hydraulic fluid. They have a unique velocity sensitive valving system that...
1963-82 Corvette Rear Trailing Arm Stud Kit. This Set Draws The Bearing Carrier and Trailing Arm Together. Set Includes 4 Studs, 4 Lockwashers, and 4 Nuts. 1 Set Does 1 Side (1 Trailing Arm). 2...
1963-79 Corvette New Power Steering Hose Set for Small Blocks. These Hoses are Made in the USA Using Only Goodyear and Gates Rubber. Set Includes 1 Small Block Pressure Hose, 1 Extend Hose, 1 Retract...
1963-79 Corvette Half Shaft U-Joint Bolt Standard Steel French Locks. These are sold in a Car Set of 4, and 1 Set Does Both Sides. Attaches Half Shaft U-Joint Flange to Rear Wheel Bearing Flange....
1963-82 Corvette Front Upper Control Arm Alignment Shim Kit. Includes 32 Pieces. 1/32" (8), 1/16" (8), 1/8" (16). Does Both Sides. 1 Kit Per Car. Made in the USA
1965-82 Corvette Right Rear Lip Seal Caliper. Each caliper is bored and sleeved back to original equipment specs with stainless steel sleeves, polished to a 4 micron finish. Each caliper is then carefully cleaned and...
1968-82 Corvette Front Sway Bar Link Kit, These are Made with the Original “RBW” Head Markings. The Washers, Grommets, Sleeves, and Nuts are Made Just Like the Originals.